Duplex Fuel Oil Packages

Features:

  • Pump Set
  • Control Panel

Specifications:

  • Series SG05 and SG407
  • Max. Capacity: 32 GPM
  • Max. Pressure: 450 PSI
  • Max. Viscosity: 38-5000 SSU
  • Temperature Range: -20ᵒ C to 50ᵒ C (-4ᵒ F to 125ᵒ F)

Options:

Basic Pump Set

  • SG405--Spur Gear Pump in cast iron construction, cUL/UL-Listed, heat treated steel gears, case-hardened shafts, needle bearings, Viton® mechanical seal, plain head
  • SG407--Spur Gear Pump in cast iron construction, cUL/UL-Listed, heat treated steel gears, case-hardened shafts, needle bearings, Viton® mechanical seal, plain head
  • Viking M drive brackets to allow pumps to be close-coupled to C faced motors (2)
  • Motors - Totally Enclosed Fan Cooled, foot mounted, NEMA C or TC, UL, CSA/US (2)
  • Common steel baseplate shall be made of heavy gauge steel plate with 1 1/2” high drip-lip and 1/2” NPT drain (1)
  • Suction Line Equipment
    • cUL/UL331-Listed Basket Strainers, cast iron body, 40 mesh stainless steel basket (2)
    • cUL/UL331-Listed Ball valves, 600 PSI pressure rated, full port (2)
    • Compound Gauges 30" Hg 0-30 {SI 2.5in Dial liquid filled CRN
    • cUL/UL842 Gauge Valves - bronze ball valves, 600 PSI rated (2)
  • Discharge Line Equipment
    • Ball Cone Type Check Valves, 400 PSI pressure rated (3) CRN
    • Ball valves, 600 PSI pressure rated, full port (2), cUL/UL-Listed 
    • Relief Valves - continuous bypass type, cast iron body, stainless steel spring (2)
    • Pressure Gauges, 0-200 PSI, 2.5” dial, liquid filled (2) CRN
    • Gauge Valves - brass ball valves, 600 PSI rated (2), cUL/UL-Listed 
  • Suction and Discharge Piping
    •  Schedule 80 carbon steel ASTM 53 or ATSM A106B piping and nipples, 150 PSI malleable iron threaded fittings
  • Unit to be coated with Vinyl Toluene Alkyd, quick dry enamel.
  • Duplex pump set to be leak tested with 100 PSI air and soap water.

Standard Pump Set

  • Include all equipment from Basic Pump Sets, as well as:
    • Pressure Switch - Dual Stage - High & Low,
    • EEMAC1 enclosure, installed
    • Magnetic Float Switch with Alarm for Drip Tray
    • Leak Detection

Premium Pump Set

  • Include all equipment from Basic Pump Sets, as well as:
    • ULC listed Flexible Connectors, SS hose/Steel nipple, set of 3
    • API 607 Steel Ball and API 602 Check Valves- installed
    • Magnetic Float Switch with Alarm for Drip Tray Leak Detection
    • Pre-plumbed Return-to-Tank Header
    • Flow Switch (2) - High Pressure to 1450 PSI

Basic Control Panel

  • Single pole circuit breaker (2) c/w through the door operation (120 volt) or individual disconnect switches, motor protectors and transformer (208-575 volt)
  • Magnetic motor starters (2)
  • Hand-Off-Auto selector switches (2)
  • Power on pilot light (white)
  • Run pilot light (green) (2)
  • Control circuit fuse
  • Lead pump failure pilot light & manual reset, lag pump start
  • P1 - Auto - P2 alternating selector switch
  • Provision to connect 3 float switches (normally closed)

Standard Control Panel

  • Include all BASIC Control Panel items, as well as:
    • Provision to connect 4 float switches and 1 redundant contactor (normally closed)
    • High pressure cut out - red pilot light & manual reset
    • Low pressure cut out - red pilot light & override timers (2) (manual reset)
    • Low and high pressure alarm signals
    • Low, high and critical high level alarm signal & red pilot light
    • Provision to connect valve (each)
    • Redundant Contactors (Back-up to Primary Contactors)
    • Drip tray leak detection alarm signal & red pilot light

Premium Control Panel

  • Include all BASIC Control Panel items, as well as:
    • Low flow signal to start lag pump c/w timers (2), red pilot lights & reset push button
    • Low, high and critical high level alarm signals & red pilot lights
    • Low flow alarm signals (2) and Relief flow alarm signals (1)
    • Provision to connect valve (each)
    • Redundant Contactors (Back-up to Primary Contactors)
    • Drip tray leak detection alarm signal & red pilot light
    • One (1) proof of flow in RTT line with red light
    • Premium Plus Control Panel

Markets and Applications:

  • Fueling diesel generators for backup electrical power generation
  • Boosting low pressure fuel oil on oil-fired boilers and oil-fired furnaces
  • Fuel oil transfer from storage to day tank
  • Typical Applications: Emergency Generators, Turbine Generators, Boilers

Benefits:

  • Compact integrated system that allows you mounting flexibility
  • Reliable fuel delivery with plumbed-and-wired standby pump
  • Alternate pumps automatically minimize run time on any one pump
  • Proven, factory manufactured sets built custom to your order
  • UL-CSA electrical control panels
  • Quick access comparison sheets, specification sheets and illustration drawings
  • Easily requested CAD submittal drawings